9
Introduction / Getting started
TV front view
1
Point the
brightness sensor
(- page 19).
IR sensor
(
- page 24)
(When using the
3D mode, these
sensors will
light in red.)
1 ! (power LED) — Power indicator
(- page 11, 50).
Left side view
3
4
5
6
7
2
2 USB 1-2 (input terminals) — Insert your USB
storage device (photo, movie, music)
(- page 44).
Note (except for 40VL20EE/E5/V5 and
46VL20EE/E5/V5 models):
Insert the “TOSHIBA Dual Band WLAN Adaptor” in
order to access a wireless network (- page 38).
3 ! (power on/standby) — Press to turn the TV
on/ standby (- page 11).
4 2 – + (volume) — These buttons adjust the
volume level.
U u (mode up/down) — These buttons select
programme position or input source.
5 p / o (programme position or input source)
— This button switches to the programme
position or the input source selection.
6 o HDMI1, 2, 4 (input terminals) — High-
De nition Multimedia Interface input receives
digital audio and uncompressed digital video
from an HDMI device (- page 34).
HDMI4 is compatible with MHL 1.
For use when connecting to a MHL-compatible
device (- page 50).
7 o (2) (Video 2 input terminals) — Standard
(composite) video and standard (analogue)
stereo audio inputs (- page 34).
Power cord
Cable holder
*
Cable holder *
* You can use the cable holder to hold the aerial
cable, video and audio cables etc.
Never grasp the holder when moving the TV.
13
14
15
8
10
11
12
96
TV back view
8 O DIGITAL AUDIO (OPTICAL) (output
terminal) — For use when connecting an
ampli er with optical type digital audio input
(- page 33).
9 LAN port — For use when connecting to DLNA
CERTIFIED™ products or Toshiba Places
(- page 38).
10 o HDMI3 (input terminal) — High-De nition
Multimedia Interface input receives digital
audio and uncompressed digital video from
an HDMI device or uncompressed digital video
from a DVI device (- pages 34).
11 A (aerial input terminal) — Analogue aerial
signal input (- page 8).
To Next Page
Loading...
