User's Manual
GETTING S TARTED
3-8
Hibernation mode
The hibernation feature saves the contents of memory to the hard disk when the
computer is turned off. The next time the computer is turned on, the previous state
is restored. The hibernation feature does not save the status of peripheral devices.
CAUTIONS: 1. While entering hibernation mode, the computer saves
the contents of memory to the HDD. Data will be lost if
you remove the battery or disconnect the AC adaptor
before the save is completed. Wait for the Built-in
HDD indicator to go out.
2. Do not install or remove a memory module while the
computer is in hibernation mode. Data will be lost.
Benefits of hibernation
The hibernation feature provides the following benefits:
◆ Saves data to the hard disk when the computer automatically shuts down
because of a low battery.
NOTE: For the computer to shut down in hibernation mode, the hiberna-
tion feature must be enabled in two places in TOSHIBA Power Saver: the
Hibernate window and the Battery Alarm item of the Alarm window.
Otherwise, the computer will shut down in Standby mode. If battery power
becomes depleted, data saved in Standby will be lost.
◆ You can return to your previous working environment immediately when you
turn on the computer.
◆ Saves power by shutting down the system when the computer receives no
input or hardware access for the duration set by the System hibernate feature.
◆ You can use the panel power off feature.
Starting Hibernation
NOTE: You can also enable Hibernation by pressing Fn + F4. See
Chapter 5, Keyboard, for details.
To enter Hibernation mode, follow the steps below.
1. Click start and click Turn Off Computer.
To Next Page
Loading...
