User’s Manual 4-6
Operating Basics
2. Grasp the drawer gently and pull until it is fully opened.
Pulling the drawer open
3. Lay the CD/DVD, label side up, in the drawer.
Inserting a CD/DVD
4. Press gently at the center of the CD/DVD until you feel it click into
place. The CD/DVD should lie below the top of the spindle, flush with
the spindle base.
5. Push the center of the drawer to close it. Press gently until it locks into
place.
When the drawer is fully opened, the edge of the computer will extend
slightly over the CD/DVD tray. Therefore, you will need to turn the CD/DVD
at an angle when you place it in the tray. After seating the CD/DVD,
however, make sure it lies flat, as shown in figure above.
Do not touch the laser lens. Doing so could cause misalignment.
Do not keep foreign matter from entering the drive. Check the back edge of
the tray to make sure it carries no debris before closing the drive.
To Next Page
Loading...
Need help?
General