- 98 -
7. When you choose the “Raw” for the Protocol,
enter the printer SOCKET PORT as the “Port
Number” and click the [OK] button. The
default port number is “8000” or “9100”. Do
not check the “SNMP Status Enabled”
checkbox.
When you choose the “LRP” for the Protocol,
enter any queue name (e.g. “lpr”) and click the
[OK] button. Do not check the “LPR Byte
Counting Enabled” and “SNMP Status
Enabled” checkboxes.
Note: When the status monitor feature is used with the
bi-directional support, select the “Raw”.
[The default port number]
9100:B-FP series, B-FV series, B-EX6 series
8000:Other
8. Click the [Next] button, and [Finish] button.
9. When the “Add Standard TCP/IP Printer Port Wizard” is finished, a new port is added.
To Next Page
Loading...
