- 66 -
Sensor
Enables selecting a sensor type.
• None
• Reflective
• Transmissive
• Transmissive (Manual Threshold)
• Reflective (Manual Threshold)
• Transmissive (Clothing Tags)
• Lower Reflective (Black mark on the reverse side)
• Lower Reflective (Manual Threshold)
• Upper Reflective (Black mark on the print side)
• Lower Reflective (Punch hole)
Select the “Transmissive (Preprinted Labels)” or “Reflective (Manual Threshold)” when the threshold has
been set through the key operation in the printer system mode.
The “Transmissive (Clothing Tags)” is available only to the B-431.
The “Lower Reflective (Black mark on the reverse side)”, “Lower Reflective (Manual Threshold)”, “Upper
Reflective (Black mark on the print side)”, and “Lower Reflective (Punch hole)” are selectable for the B-852
or B-852R.
Label Gap
Enables setting the inter-label gap size. In the case of tag paper, enter the non-printable area size.
Issue Settings
Issue Mode
• Batch Mode (with Back Feed)
• Strip Mode (with Back feed)
• Strip Mode (when using the applicator)
• Partial Cut (without Back Feed)
• Batch Mode
• Cut Mode
When the cutter unit is installed on the printer to perform the cut issue, select the “Batch Mode (with Back
Feed) or the “Cut Mode”.
When the strip module is installed on the printer to perform the strip issue, select the “Strip Mode (with Back
Feed)” or the “Strip Mode (when using the applicator)”.
When the “Partial Cut (without Back Feed)” is selected, this option will be always specified.
Post-Print Action
Enables selecting whether the cut operation is performed or not.
• None
• Cut
• Partial Cut
• Linerless Cut
• Cut and Pause
• Pause (This is not supported.)
When the “Partial Cut” is selected, the “Partial Cut (without Back Feed)” will be always set for the Issue
Mode.
When the “Linerless Cut” is selected, the “Batch Mode (with Back Feed)” will be always set for the Issue
Mode.
The “Cut and Pause” and “Pause” are not supported at present.
To Next Page
Loading...
