Toshiba B-EP2DL-GH40-QM-R - Page 92

- 90 -
• When a control code or special code is used with the bar code font specified, refer to the following table
and enter the corresponding data.
In the case a caret “^” is used, enter “^^” because the caret “^” is the default function character. If the
function character is changed from “^” to the other in the [User Commands] of the [Advanced Options],
replace the “^” with the specified character.
Control code
Input data
Control code
Input data
Control code
Input data
>@ (00H)
N/A
>P (10H)
^<DLE>
>0
>
>A (01H)
^<SOH>
>Q (11H)
^<DC1>
>1
^<DEL>
>B (02H)
^<STX>
>R (12H)
^<DC2>
>2
^3
>C (03H)
^<ETX>
>S (13H)
^<DC3>
>3
^2
>D (04H)
^<EOT>
>T (14H)
^<DC4>
>4
^s or ^S
>E (05H)
^<ENQ>
>U (15H)
^<NAK>
>5
^c or ^C
>F (06H)
^<ACK>
>V (16H)
^<SYN>
>6
^b or ^B
>G (07H)
^<BEL>
>W (17H)
^<ETB>
>7
^a or ^A
>H (08H)
^<BS>
>X (18H)
^<CAN>
>8
^1
>I (09H)
^<HT>
>Y (19H)
^<EM>
>J (0AH)
^<LF>
>Z (1AH)
^<SUB>
>K (0BH)
^<VT>
>[ (1BH)
^<ESC>
>L (0CH)
^<FF>
>\ (1CH)
^<FS>
>M (0DH)
^<CR>
>] (1DH)
^<GS>
>N (0EH)
^<SO>
>^ (1EH)
^<RS>
>O (0FH)
^<SI>
>_ (1FH)
^<US>