Toshiba B-FV4T-TS14-QM-R - Restoring Factory Settings

3PrinterOperationsToshibaB‐FV4TOwner’ sManual
27
3.2.2 DumpMode
The printer will enter the Dump mode after running a self test. In this mode,
charactersareprintedinhexadecimalcodes,allowingusersandengineerstodebug
thesystem.
Toreturntotheonlinemode:
 Turnofftheprinter,andturnitonagain.
3.3RestoreYourPrintertoFactorySettings
Someproblemscanbesolvedbyrestoringtheprintertoitsfactorysettings.Dothe
followingtoresetyourprinter.
1. Turnofftheprinter.
2. PressandholdtheFEEDbutton,andturnontheprinter.
3. Bothstatuslightswilllightupsolidorangeforafewseconds.Next,theyturnto
greenshortly,andthenturntoothercolors.Whenbothlightsturntored,release
theFEEDbuttonimmediately.
4. Press and holdthe FEED button for 3 seconds and release it. Both status lights
willblinkredthreetimes,andturntosolidorangeforafewseconds.Afterthat,
LED2goesoutwhileLED1turnstosolidgreen.


NoteInstep4,ifyoudonotholdtheFEEDbuttonlongenough,LED2 
willblinkorangethreetimeswhileLED1goesout.Itmeanstheprinter
isnotreset.
