Toshiba B-SX5T - Page 31

2. SUPPLY SPECIFICATIONS EO10-33013B
(Revision Date: Apr. 24, 2008)
2.5 SPECIFICATION OF RFID TAG (for B-SX704-RFID-U2-EU/AU -R)
2-15
7) Printing on Bump (Chip/Antenna) Area
Embedding RFID tags in labels creates bumps in a chip/antenna area in the labels, causing incomplete
printing.
Especially, in the areas 5 mm from and left and right sides of the RFID-tag embedded area shown in
the figure below, uneven printing or incomplete printing can occur easily.
* The degree of poor printing quality differs depending on height of a chip/antenna used.
8) Ambient temperature
Low operating temperature deteriorates wireless performance, under which conditions writing data on
an RFID tag may fail.
9) Strip issue
Stripping performance in strip issue mode depends on the type of glue, tag, and backing paper. For
some RFID supplies used, an issue may not be performed properly in strip issue mode.
Media
feed
direction
RFID tag
embedded
area
Print qualit
y
on the
sides of RFID tag is
not guaranteed.
Print quality on
bumps is not
guaranteed.
Print quality on
bumps is not
guaranteed.
Print quality on
the IC chip is not
guaranteed.
5mm
5mm