Toshiba BA420T Series - APPENDIX 1 INTERFACE; Standard Interfaces (USB, LAN, Bluetooth, NFC)

6. APPENDIX 1 INTERFACE ENGLISH VERSION
6. APPENDIX 1 INTERFACE
E6-1
6. APPENDIX 1 INTERFACE
USB interface (Standard)
Standard: Conforming to V2.0 High speed
Transfer type: Control transfer, Bulk transfer
Transfer rate: 480M bps
Class: Printer class
Control mode: Status with the receive buffer free space information
Number of ports: 1
Power source: Self power
Connector: Type A and Type B
Pin No.
Signal
1
VCC
2
D-
3
D+
4
GND
LAN (Standard)
Standard: IEEE802.3 10BASE-T/100BASE-TX
Number of ports: 1
Connector: RJ-45
LED status: Link LED
Activity LED
LAN cable: 10BASE-T: UTP category 3 or category 5
100BASE-TX: UTP category 5
Cable length: Segment length Max. 100 m
LED
LED Status
LAN status
Link
ON
10Mbps link or 100Mbps link is detected.
OFF
No link is detected.
* Communication cannot be made while
the Link LED is off.
Activity
ON
Communicating
OFF
Idle
Link LED (Green)
Activity LED (Orange)
NOTE:
To prevent radiation and reception of electrical noise, the interface cables must meet the following requirements:
• In case of a parallel interface cable or serial interface cable, fully shielded and fitted with metal or metallised
connector housings.
• Keep as short as possible.
• Should not be bundled tightly with power cords.
• Should not be tied to power line conduits.
• A parallel interface cable to be used should conform to IEEE1284.