2.5
Wiring of the power supply
6E8C1118
21
CAUTION
1. Always turn off the power before wiring the cables.
Working with the power on can cause electrocution.
2. Use covered crimp terminals or cover the module wire with tape so that there
is no exposed conducting parts.
Fasten the terminal covers securely to the terminals when wiring is finished.
Exposed parts can cause electrocution.
3. Always ground the model 3000.
Failing to ground the unit can cause electrocution or malfunction.
4. Connect to rated power supply.
Connecting to wrong power supply can cause explosion or fire.
5. Wiring must be performed by an experienced person.
Wiring error can result in fire, malfunction, or electrocution.
6. Do not connect any cables to the NC terminals.
NOTE:
Terminal screw size is M3.5. Use crimp terminal with width of 7mm or less for M3.5
screw.
To Next Page
Loading...
