English - 31
Press the ❷buttons to select Done and then
press OK button to confirm manual setting.
•
Repeat this procedure from step 5 onwards,
until all the required stations have been stored.
12
To... Then....
Select a Character
Press the ❷button until
the required name character
is displayed (letters, numbers
or “ - ” character)
Move to the next or
Press the ➛❿buttons
previous character
respectively.
10
If you.. Then....
Wish to store the
• Press the
❷buttons until
station displayed the MFT is selected.
• Press the
➛❿buttons to
adjust the picture, if neces-
sary.
•
Select Done to store the station.
Do not wish to store
• Press the
❷buttons until
the station displayed
the CH is selected.
• Press the
➛❿buttons to
go on scanning the frequen-
cy band and display the
next station.
• Go back to the beginning of
step.
11
Clearing a Preset
Station
If you have stored a TV station:
• That you do not require
• At the wrong programme positiom you can cancel it.
Open “MENU”
With the DVD in Stop mode, press the MENU
button.
1
Select “Setup”
Using the ❷buttons, move the selection bar
to “Setup” then press
❿ or OK button to select.
2
Select “Install”
Using the ❷buttons, move the selection bar
to “Install”, then press
❿ or OK button to select.
3
Select “Manual Setup”
Using the ❷buttons, move the selection bar
to “Manual Setup” then press
❿or OK button to
select.
4
To Next Page
Loading...
