Press the or❷button to select Swap.
To change the programme number assigned to a
station press the OK button on the remote con-
trol.
• For example, to move a TV station in pro-
gramme 1 to programme 3).
6
Press the ❷buttons to select required posi-
tion. And then press OK button again to swap the
position.
7
On completion, press the RETURN button four
times to exit the menu.
8
Press the ❷buttons, until the required preset
TV programme is selected then press
❿ or OK
button to select.
5
Setting the VCR Output
Channel
Open “MENU”
With the DVD in Stop press the MENU button.
1
Select “Setup”
Using the ❷buttons, move the selection bar
to “Setup” then press OK to select.
2
Select “Install”
Using the ❷buttons, move the selection bar
to “Install”, then press OK to select.
3
Select “VCR Output CH”
Move the selection bar to “VCR Output CH”
using the
❷buttons then press OK to select.
4
Select the required output channel (Ch21~Ch69)
by pressing the
or❷ button then press OK to
Select.
ÆCh21 Æ ..Ch38 Æ ..Ch69
5
On completion, press RETURN button four times
to exit the menu. Then tune your television again
6
System Setup
To Next Page
Loading...
