72 - English
Recording
The numbers next to each TV programme list-
ing are Videoplus+ code numbers, which
allow you to programme your DVD Recorder-
VCR instantly with the remote control. Tap in
the Videoplus+ code for the programme you
wish to record.
Videoplus+ is a trademark of Gemstar
Development Corporation. The Videoplus+
system is manufactured under licence from
Gemstar Development Corporation.
Note
If the programme and times are correct, press
the OK button.
4
Press the ON/STANDBY button to activate the
timer.
5
Refer to page 76 if you wish to:
• Check that your DVD Recorder-VCR has been
programmed correctly
• Cancel a preset recording
6
Press the OK button.
• The information concerning the programme is
displayed.
• When using the Videoplus+ function for the
first time with stored stations, the programme
number flashes. On the first occasion, you
must enter
the station number manually by pressing the
❷ buttons.
3
Refer to the following page if:
• The programme number or times flash
• You wish to modify the programme
To Next Page
Loading...
