Toshiba e-studio 16 - Setting Image Density

3-3
3
1. ERROR MESSAGES
If an abnormal condition arises in the machine or an incorrect operation is performed, an alarm buzzer
is generated for about 4 seconds and a message to indicate the nature of the error appears in the LCD
Display. In that case, take corrective action.
For error messages that are not described in this chapter, refer to the e-STUDIO16/20/25 OPERATOR’S
MANUAL FOR COPYING FUNCTION or e-STUDIO16/20/25 OPERATOR’S MANUAL FOR FACSIMILE
FUNCTION.
Operation Error
Check E-mail Error
The following table describes error messages displayed when pressing the key.
Error Message
Network access
error
Not POP3 receive
mode
Not exist POP3
server
Not exist IP
address
Not exist E-mail
Bad POP3 login name
Not connect POP3
server
Cause
The Network Interface Card or
Internet Fax unit has been
damaged.
The Receive Mode is set to SMTP.
The machine cannot find the POP
server in the network.
The IP address of this machine has
not been assigned.
No E-mail has been received.
Your user name is incorrect or
locked to log in the POP server, or
the password is incorrect.
The machine cannot connect to the
POP server.
Solution
The Network Interface Card or
Internet Fax unit must be replaced.
Call for service.
Select POP for the Receive Mode.
If the Receive Mode is set to SMTP,
the [CHECK E-MAIL] key is not
available.
Check the IP address of the POP
server is set correctly. If it is
correctly set, ask your network
administrator if the mail server is
correctly active.
Assign the IP address of this
machine.
-
Check the POP login name and
password is set correctly. Of they
are correctly set, ask your network
administrator if your login name is
not locked.
Check the IP address of the POP
server is set correctly. If it is
correctly set, ask your network
administrator if your POP account is
correctly set on the mail server.