2-3
1
2
3
4
5
6
7
9
10
11
12
8
INSTALLING THE TOSHIBA Viewer
Before installing TOSHIBA Viewer, your TOSHIBA e-STUDIO16/20/25 must be connected to your PC
via a LAN cable suitable for bi-directional communications.
NOTE
Please make sure that following terms are satisfied.
• When using Windows NT 4.0, make sure you have Administrator access rights.
• Close all applications that are running to avoid any conflicts during installation.
• The TOSHIBA e-STUDIO16/20/25 connected to your PC is powered on.
Installation
Prompts may vary depending on your PC configuration.
The screens show examples of Windows 2000.
1
Insert the CD-ROM
• Click Start and select Run.
2
Type “D:\Toshiba Viewer via Network\
Setup.exe”
• Type “D:\Toshiba Viewer via Network\Setup.exe”
where D is your CD-ROM drive.
• Click OK.
3
Select Language
• Click OK.
4
Start the Installation
• Click Next.
To Next Page
Loading...
