e-STUDIO160/200/250 FUSER UNIT/PAPER EXIT UNIT 14 - 12 December 2002 TOSHIBA TEC
3. Remove the spring from the fuser unit and de-
tach the heat roller separator.
4. Remove the spring from the heat roller sepa-
rator.
Fig.14-7-8
087-5
Spring
Heat roller
separator
Fig. 14-7-9
Screw
Screw
Housing
088
[D] Housing
1. Remove fuser unit. (See Fig. 14-7-1)
2. Open the fuser front cover.
(See Fig. 14-7-7)
3. Remove 2 screws and detach the housing.
Fig. 14-7-10
Screw
Housing assembly
089-1
Screw
1. Remove fuser unit. (See Fig. 14-7-1)
2. Remove heater thermistor. (See Fig. 14-7-5)
3. Remove 2 screws and detach the housing as-
sembly.
4. Loosen 2 knobs and detach the fuser front
cover.
Fig.14-7-11
089-4
Fuser front cover
Knob
[E] Fuser thermostat/fuser front cover
To Next Page
Loading...
