Toshiba e-studio 160 - Disassembly and Replacement (Fuser Unit); Fuser Thermostat and Front Cover Removal

December 2002 TOSHIBA TEC 14 - 13 e-STUDIO160/200/250 FUSER UNIT/PAPER EXIT UNIT
8. Remove 4 screws (A type: for NAD/SAD models,
B type: for ASD/AUD/CND/MJD models) to
release the heater cover assembly.
Fig. 14-7-14
9. Remove 2 screws and detach the fuser
thermostat 1.
Fig. 14-7-15
Screw
Heater cover
assembly
Screw
Screw
Fuser thermostat 1
090-3
091-4
A type B type
5. Remove the heat roller separator.
(See Fig. 14-7-8)
6. Remove one screw and detach the spring plate.
Fig. 14-7-12
089-3
Screw
7. Release 2 hooks to detach the partition plate.
Fig. 14-7-13
090-2
Partition plate
Screw
Spring plate