December 2002 TOSHIBA TEC 14 - 19 e-STUDIO160/200/250 FUSER UNIT/PAPER EXIT UNIT
Fig. 14-7-31
095-2
C-ring
HR drive gear 2
Heat roller bushing
9. Remove the C-ring to detach the HR drive gear
2 and the heat roller bushing.
10. Remove 2 screws, detach the arm holder, and
then remove the guide plate.
Note: When HR drive gear 2 is replaced, apply
0.075g of white grease (molykote HP-300)
to the area around the boss inside of HR
drive gear 2. (See Fig. 14-7-25)
Boss
Fig. 14-7-32
095-3
Guide plate
Arm holder
Arm holder
Screw
11. Remove the C-ring to detach the heat roller
bushing.
Fig. 14-7-33
Fig. 14-7-34
097-2
097-8
Heat roller bushing
C-ring
Heat roller
12. Remove heat roller.
Note: When heat roller is replaced, apply 0.075g
of white grease (molykote HP-300) to the
area around the boss inside of HR drive
gear 2. (See Fig. 14-7-25)
To Next Page
Loading...
