Toshiba e-studio 160 - Removal and Reinstallation of Covers and PC Boards; Cover Removal - Right Covers and Side Cover Assembly

December 2002 TOSHIBA TEC 2 - 25 e-STUDIO160/200/250 OUTLINE OF THE MACHINE
Fig.2-6-14
Screw
Screw
Upper right cover R
Lower right cover R
Side cover
013-3
[N] Upper right cover R/Lower right cover R
In case that an ADU and SFB are not attached
or a SFB is attached.
1. Open side cover.
2. Remove 2 screws and detach upper right cover
R.
3. If a SFB (MY-1016) is attached to the copier,
detach it.
4. Remove 2 screws and detach lower right cover
R.
In case that an ADU is attached or an ADU
and SFB are attached.
1. Open an ADU (MD-0101) and release the wire.
2. Open side cover.
3. Remove 2 screws and detach upper right cover
R.
4. Detach an ADU (MD-0101) from the copier.
5. If a SFB (MY-1016) is attached to the copier,
detach it.
6. Remove 2 screws and detach lower right cover
R.
Fig. 2-6-15
4. Remove 2 screws securing stopper and guide
pin, then detach paper guide B, spring and side
cover assembly.
Fig. 2-6-16
Side cover
Clamp
Connector
Guide pin
Paper guide B
Guide pin
Screw
Stopper
Side cover assembly
Screw
Stopper
014
015
Spring
[O] Side cover assembly
1. Open ADU (MD-0101) if it is attached.
2. Detach upper right cover R. (See Fig.2-6-14)
3. Detach one connector and release the clamp.