Toshiba e-studio 160 - Removal and Reinstallation of Covers and PC Boards; Cover Removal - Right Cover and Front Frame Cover

e-STUDIO160/200/250 OUTLINE OF THE MACHINE 2 - 26 December 2002 TOSHIBA TEC
Fig. 2-6-18
Fig. 2-6-19
[P] Right cover
1. If an ADU (MD-0101) and/or SFB (MY-1016)
are attached to the copier, detach it.
2. Detach lower right cover R. (See Fig. 2-6-14)
3. Remove 2 screws, release 2 hooks, and detach
right cover.
Fig. 2-6-17
Hook
Right cover
Screw
Exit cover
Side cover
Front frame cover R
Hook
Hook
Front frame cover F
016
017
018
Screw
[Q] Front frame cover F/R
1. If a Finisher (MJ-1011) is attached to the copier,
detach the finisher plate and junction block.
2. If a JSP (MJ-5001) or OCT (MJ-5002) is
attached to the copier, detach it.
3. If an Original Cover (KA-1600PC), ADF
(MR-2012), or the RADF (MR-3011) is attached
to the copier, open it.
4. If an ADU (MD-0101) is attached to the copier,
open it.
5. Detach scanner cover. (See Fig. 2-6-3)
6. Detach control panel front cover.
(See Fig. 2-6-6)
7. Detach control panel bottom cover.
(See Fig. 2-6-7)
8. Open side cover.
9. Open exit cover.
10. Remove one screw, release 4 hooks, and
detach front frame cover F and front frame
cover R.