e-STUDIO167/207/237 © 2007 - 2008 TOSHIBA TEC CORPORATION All rights reserved
SCANNER
6 - 18
[B] Scanner top cover
Notes:
1. Install the ADF original glass so that the
attached Mylar sheet is placed on the
front side.
2. When installing the ADF original glass,
place it between 2 small guides with its
left-hand side pushed to the scanner top
cover.
Fig. 6-15
(1) Take off the original glass.
P.6-17 "[A] Original glass"
(2) Take off the front upper cover.
P.2-20 "[F] Front upper cover"
(3) Take off the control panel unit.
P.5-7 "[A] Control panel unit"
(4) Remove 8 screws and take off the scanner
top cover.
Fig. 6-16
Guide
Guide
Mylar
Scanner top cover
To Next Page
Loading...
