e-STUDIO167/207/237 © 2007 - 2008 TOSHIBA TEC CORPORATION All rights reserved
GENERAL OPERATION
4 - 4
4.2.4 Bypass feed copying
1) Insert a sheet of paper into the bypass tray.
→ Bypass paper sensor ON
- Bypass feed priority state.
2) Press the [START] button
→ “READY” Æ “COPYING”
→ CIS LED ON
→ Scan motor ON → CIS unit move forward
→ Polygonal motor rotates in high speed
→ Main motor and exit motor ON
- The drum, fuser unit, developer unit and exit roller are driven.
3) Bypass feeding
→ Main charger, developer bias and discharge LED ON. Fans are rotated in high speed.
→ Bypass pickup solenoid ON
- The bypass pickup roller start to rotate.
- The bypass pickup roller is lowered.
- The bypass feed roller start to rotate.
→ Paper reaches the registration roller
→ Aligning operation
→ After a certain period of time, the bypass pickup solenoid OFF
4) Hereafter, the operation 3) through 6) of P.4-3 "4.2.3 Drawer feed copying" is repeated.
4.2.5 Interruption copying
1) Press the [INTERRUPT] button
→ LED “INTERRUPT” ON
→ Copying operation in progress is temporarily stopped. CIS unit return to appropriate positions
→ “Job interrupted” is displayed
→ Automatic density and reproduction ratio 100% are set (The set number remains the same)
2) Select the desired copy condition
3) After the interruption copying is finished:
→ LED “INTERRUPT” OFF by pressing the [INTERRUPT] button
→ “READY to resume job” is displayed
4) Press the [START] button
→ The copying operation before the interruption is resumed
To Next Page
Loading...
