e-STUDIO167/207/237 © 2007 - 2008 TOSHIBA TEC CORPORATION All rights reserved
DRIVE UNIT
9 - 6
9.5 Disassembly and Replacement
[A] Main motor (M3)
[B] Toner motor (M2)
(1) Take off the rear cover.
P.2-22 "[J] Rear cover"
(2) Disconnect 1 connector, remove 2 screws,
and then take off the main motor.
Fig. 9-3
(1) Take off the rear cover.
P.2-22 "[J] Rear cover"
(2) Disconnect 1 connector, remove 1 screw,
take off the toner motor with the bracket, and
then remove 1 bushing and 1 gear.
Fig. 9-4
Connector
Main motor
Bracket
Connector
Bushing
Gear
Tonner motor
To Next Page
Loading...
