5
© 2007 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO167/207/237
CONTROL PANEL
5 - 3
5.2.2 Message
No. Message Condition of machine Notes
1 Wait warming up Being warmed up
• Displayed after the main switch is
turned ON up until the machine
becomes ready for copying
-
2 READY Standby for copying
• The machine is ready for copying
and operator's instructions on copy-
ing conditions can be input
• Returns to the default condition if
no key is pressed for the setting
time of auto clear timer
• Copy quantity indicator shows
"1"When a digital key is pressed,
that number indicates the set quan-
tity
• The set quantity can be cleared to
"1" by pressing the CLEAR/ STOP
key
• Bypass copying is possible
3 COPYING Now copying
• Displayed by pressing the START
key
• Copy quantity indicator becomes
"ex. 3→ 2 → 1→ 3" and copying is
completed
• After completion of copying, the
copy quantity indicator returns to
the initially set number
4 Saving energy Energy saver conditions • Reset by pressing the any key
except the ENERGY SAVER key
5 Select original size Platen sort copying standby state • When using original cover
6 - Timer off
• No message is displayed in the dis-
play panel
-
7 Cassette * empty Indication of lack of paper
• Indicates when there is no paper in
cassette
• Bypass copying is possible
• Supply paper to the selected cas-
sette
• Select another cassette
8 Toner empty Indication of lack of toner
• The toner in the toner cartridge
becomes empty
• When this message is displayed, it
is not possible to copy
• Reset after the toner is supplied
and the front cover is closed
9 Misfeed in bypass Bypass paper jamming (SFB)
• Paper jams at the bypass tray
The machine returns to normal condi-
tions automatically when the paper out
is pulled from the bypass tray
10 Misfeed in copier
(Copier machine)
Paper jammed in the machine Remove the paper jammed in the
copier by following the messages
11 Misfeed in doc. Feeder
(ADF)
Original jammed
• An original is jammed in the ADF
Open the ADF jam access cover and
the ADF unit, and remove the jammed
original
12 Misfeed in duplexer
(ADU)
Paper jammed in the ADU Remove the paper jammed in the
copier by following the message
13 Call for service Some part of the mechanism, motors,
switches or sensors is abnormal
Turn OFF the machine, remove the
cause of the fault and turn the machine
back ON
14 Time for maintenance Indication of PM cycle
• Displayed when it is time for pre-
ventive maintenance and inspection
• Capable of copying
Maintenance and inspection by a quali-
fied service technician
To Next Page
Loading...
