e-STUDIO167/207/237 © 2007 - 2008 TOSHIBA TEC CORPORATION All rights reserved
GENERAL OPERATION
4 - 2
4.2 Description of Operation
4.2.1 Warming-up
1) Initialization
Power ON
→ Heater lamp ON
→ “Please wait” is displayed
→ Fan motors ON
→ Initialization of scanning system
- The CIS unit moves to the home position.
- The CIS unit moves to the peak detection position.
- The LED of CIS is turned ON.
- Peak detection (white color is detected by the shading correction plate)
- The LED of CIS is turned OFF.
- The CIS unit moves to the home position.
→ “READY (WARMING UP)” is displayed
2) Pre-running operation (Only when the temperature is at 16 °C or less)
The pre-running operation is started when the temperature of the fuser roller surface reaches a cer-
tain temperature.
→ The main motor is turned ON
- Fuser roller rotated.
- Drum rotated.
→ Pre-running operation stops after 15 seconds
3) When the surface temperature of the fuser roller becomes sufficient for fusing,
→ “READY” is displayed
4.2.2 Ready state (ready for copying)
Buttons on the control panel enabled
→ When no button is pressed for a certain period of time,
- Set number “1” is displayed. Equipment returns to the normal ready state.
To Next Page
Loading...
