e-STUDIO167/207/237 © 2007 - 2008 TOSHIBA TEC CORPORATION All rights reserved
SCANNER
6 - 22
[F] Platen sensor (S2)
(3) Release 2 latches, take off the CIS home
position sensor, release the harness from
harness clamp and disconnect 1 connector.
Fig. 6-24
(1) Take off the scanner top cover.
P.6-18 "[B] Scanner top cover"
(2) Remove 1 screw and take off the sensor with
the bracket.
(3) Disconnect 1 harness clamp and 1 connec-
tor.
Fig. 6-25
(4) Release 2 latches and take off the platen
sensor.
Fig. 6-26
CIS home position sensor
Connector
Bracket
Connector
Platen sensor
To Next Page
Loading...
