e-STUDIO167/207/237 © 2007 - 2008 TOSHIBA TEC CORPORATION All rights reserved
GENERAL OPERATION
4 - 10
(E) Developer unit not installed properly
(F) Call for service
Error code is displayed instead of the set number by pressing the [CLEAR] button and [8] button
simultaneously when the service call lamp is blinking.
Refer to the error code table in the Service Handbook.
• Disconnection of the connectors of the developer unit
“Set process unit” is displayed.
[START] button disabled.
Solution: Connect the connectors of the developer unit and close the front cover.
To Next Page
Loading...
