Installing the Printer on Mac OS 8.6/9.x 173
2
Select the LaserWriter 8 icon (and select the AppleTalk zone if con-
figured). Then select this equipment displayed in the list, and click
[Create].
y The Select a PostScript Printer Description File dialog box appears.
3
Select the PPD file (TOSHIBA_e-ST450_452Series) or (TOSHIBA_e-
ST280_282Series) for the equipment and click [Select].
4
Select each option according to the configuration of this equipment
and click [OK].
y Finisher
Not Installed — Select this if a finisher is not installed.
Single-Position Stapler — Select this when the Hanging Finisher is installed.
Multi-Position Stapler — Select this when the Finisher or Saddle Stitch Finisher is
installed.
Multi-Position Stapler and Hole Punch — Select this when the Finisher or Saddle
Stitch Finisher and Hole Punch unit are installed.
Job Separator — Select this when the Job Separator is installed.
Offset Stacker — Select this when the Offset Stacker is installed.
When you select “Multi-Position Stapler” or “Multi-Position Stapler and Hole Punch”, the
saddle-stitching function will be selectable for printing. However, saddle-stitching is
available only when the Saddle Stitch Finisher is installed.
To Next Page
Loading...
