Printing from Application on Mac OS 8.6 to 9.x 313
- Job Separator Lower — Select this to route the output to the lower tray of the Job Sep-
arator.
y “Stapling and hole punching cannot be performed according to the type of the Finisher
installed and the destination setting.
y When "Auto" is select at the Destination option, the paper might be delivered to a tray
which cannot carry out stapling or hole punching according to the setting of the equip-
ment.
y For e-STUDIO452 Series, “Tray 1” and “Tray 2” can be selected when the Hanging Fin-
isher, Finisher (Type A), Finisher (Type B), or Saddle Stitch Finisher are installed.
y When the Finisher (Type B) is installed in the e-STUDIO452 Series and stapling is
enabled, select “Tray 2”.
y For e-STUDIO282 Series, “Tray 1” and “Tray 2” can be selected when the Hanging Fin-
isher is installed, and “Tray 1” can be selected when the Saddle Stitch Finisher is
installed.
y When the optional Job Separator is installed, you can select “Job Separator Upper” and
“Job Separator Lower” instead of “Inner Tray”.
2) Hole Punch
This sets whether or not a print job is hole punched.
- Off
— Select this to print without hole punches.
- Long Edge Punch without rotation — Select this to create holes on the left side for the
portrait document, or on the top for the landscape document.
- Short Edge Punch without rotation — Select this to create holes on the top for the por-
trait document, or on the right for the landscape document.
- Long Edge Punch with 180 degree rotation — Select this to create holes on the right
side for the portrait document, or on the bottom for the landscape document.
To Next Page
Loading...
