e-STUDIO167/207/237 © 2007 - 2008 TOSHIBA TEC CORPORATION All rights reserved
PAPER FEEDING SYSTEM
10 - 16
[H] Bypass pickup solenoid (SOL2)
[I] Bypass pickup clutch / Bypass feed clutch
(1) Take off the bypass unit.
P.10-10 "[A] Bypass unit"
(2) Remove 1 screw.
Fig. 10-23
(3) Release the harness from the harness clamp
and slide the pickup solenoid with the spring
upward to take it off.
Note:
When installing the bypass pickup solenoid,
be sure to place the spring between the arm
and the solenoid.
Fig. 10-24
(1) Take off the bypass unit.
P.10-10 "[A] Bypass unit"
(2) Remove 1 E-ring, 1 bushing and 2 screws.
Then take off the 1 bracket and 2 gears.
Fig. 10-25
Bypass unit
Screw
Bypass pickup solenoid
Spring
Gear
Gear
Bracket
Bushing
E-ring
To Next Page
Loading...
