Toshiba e-studio 207 - Disassembly and Replacement

e-STUDIO167/207/237 © 2007 - 2008 TOSHIBA TEC CORPORATION All rights reserved
AUTOMATIC DUPLEXING UNIT (ADU) (OPTION: MD-0103)
14 - 12
14.7 Disassembly and Replacement
[A] Automatic Duplexing Unit (ADU)
(1) Take off the right rear cover.
 P.2-22 "[I] Right rear cover"
(2) Remove 1 screw and 1 ground wire.
(3) Disconnect 1 connector.
Fig. 14-8
(4) Open the transfer unit and release the ADU
stopper.
(5) Take off the ADU cover while sliding it toward
the right.
Fig. 14-9
(6) Remove 4 screws and take off the ADU.
Note:
When installing the ADU, be sure to put the
ADU stopper on the rear side through the
rear slit of the ADU.
Fig. 14-10
Ground wire
Connector
ADU stopper
Slit ADU stopper
ADU