2
© 2007 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO167/207/237
OUTLINE OF THE MACHINE
2 - 25
[D] Paper feed controller PC board (PFC)
Note:
This paper feed controller PC board is optional for NAD, CND and MJD.
(3) Disconnect 2 connectors, remove 1 screw,
and then take off the fuse PC board by lifting
it up.
Fig. 2-28
(1) Take off the rear cover.
P.2-22 "[J] Rear cover"
(2) Disconnect 2 connectors, remove 4 screws,
and then take off the paper feed controller
PC board and mylar sheet.
Notes:
• If the ADU (optional) is installed, discon-
nect 2 connectors of the ADU with other
connectors at the same time before tak-
ing off the paper feed controller PC board.
• If the PFP (optional) is installed, discon-
nect 2 connectors of the PFP with other
connectors at the same time before tak-
ing off the paper feed controller PC board.
Fig. 2-29
Connector
Fuse PC board
Connector
(
PFP
)
Connector
(
ADU
)
Paper feed controller
PC board
Connector
Mylar
To Next Page
Loading...
