e-STUDIO167/207/237 © 2007 - 2008 TOSHIBA TEC CORPORATION All rights reserved
GENERAL OPERATION
4 - 8
(C) Misfeed in equipment
• Exit sensor detects jamming of the leading edge of paper.
Registration clutch ON
Fig. 4-1
Less than 1.808 sec.
Exit sensor ON
If the exit sensor is not turned ON after 1.808
sec.
Paper jam (E01) The copying operation is
stopped.
• Exit sensor detects jamming of the tailing edge of paper.
Registration clutch OFF
Fig. 4-2
Less than 1.759 sec.
Exit sensor OFF
If the exit sensor is not turned OFF after 1.759
sec.
Paper jam (E02) The copying operation is
stopped.
• Immediately after the power ON
Any of all sensors on paper transport path detects paper (ON)
Paper jam (E03)
• Front cover is opened during copying
Paper jam (E41)
• The registration sensor (S4) is not turned ON in a fixed period of time when paper is fed out of the
ADU.
Paper jam (E11)
Registration clutch
Exit sensor
Timer
0
Paper jam (E01)
ON
ON
1.808sec.
Registration clutch
Exit sensor
Timer
0
Paper jam (E02)
ON
OFF
1.759sec.
To Next Page
Loading...
