6.SETTING ITEMS
User Functions Menu Items 103
6 SETTING ITEMS
INITIAL
SETUP
ECM ON, OFF Switch the ECM (Error Correction Mode)
communication ON or OFF.
ECM is an internationally standardized
communication mode that automatically
corrects errors that occur during fax
transmissions. With this setting option
ON, even when the transmitted data have
been affected by noise during
communication, this mode allows good
communication without image distortion
by automatically resending the part that
have been affected.
Both the sender and the
receiver must have the ECM
function to make ECM
communication available.
When affected by noise during
communication, communication
time is slightly longer than
usual. Even when the ECM
communication is used, an error
may occur depending on the
line status.
The ECM communication is not
available for voice
communication.
RX MODE AUTO, MANUAL Sets the default setting for fax reception
mode.
The following are required for
manual reception.
- Install an external telephone
- Set [REMOTE RX] to [DIAL]
- Receive the fax in manual
reception or remote reception
when you have an incoming
call.
REMOTE RX OFF, DIAL Sets the default setting for remote fax
reception mode.
When this is set to [DIAL], the
equipment does not enter the energy
saving mode (sleep mode) even if
the [ENERGY SAVER] button is
pressed. For details of the energy
saving mode, refer to the User’s
Guide.
EASY
MANUAL TX/
RX
EASY MODE,
ADVANCED MODE
Selects whether or not to display the TX/
RX selection screen when you send/
receive a fax manually while an original is
not placed on the RADF.
Menu Functions Settings Descriptions / Reference Pages
To Next Page
Loading...
