e-STUDIO2500c/3500c/3510c
PCL6 PS3 Mac
* This adjustment will have an effect only on Auto or Color mode printing.
(3) Enter adjustment mode [05]. Change the values for codes [8050 to 8065] to adjust the color density.
• Adjust the value for [05] code corresponding to the print option to be applied (PDL and Halftone).
Ex.: • When printing on Windows is performed with the following options selected: PCL6, Image Quality
Type = General, Halftone = Auto
> Text area
Change the values for Y: 05-8062, M: 05-8063, C: 05-0864 and K: 05-8065.
> Graphic and image area
Change the values for Y: 05-8058, M: 05-8059, C: 05-8060 and K: 05-8061.
• When printing on Macintosh is performed with the following option selected: Image Type =
Photograph, Halftone = Smooth
> Change the values for Y: 05-8050, M: 05-8051, C: 05-8052 and K: 05-8053.
* Printing on Macintosh is performed in PostScript. (See the "PS3" row in the table below.)
Color to
adjust
PDL Halftone [05] code
Subcode
Recommended value
Acceptable
value range
Default
Smooth
05-8058 0/1/2
PCL5c
Detail 05-8062 0/1/2
Smooth 05-8050 0/1/2
Y
(Yellow)
PS3
Detail
05-8054 0/1/2
Smooth
05-8059 0/1/2
PCL5c
Detail
05-8063 0/1/2
Smooth
05-8051 0/1/2
M
(Magenta)
PS3
Detail
05-8055 0/1/2
Smooth
05-8060 0/1/2
PCL5c
Detail
05-8064 0/1/2
Smooth
05-8052 0/1/2
C
(Cyan)
PS3
Detail
05-8056 0/1/2
Smooth
05-8061 0/1/2
PCL5c
Detail
05-8065 0/1/2
Smooth
05-8053 0/1/2
K
(Black)
PS3
Detail
05-8057 0/1/2
Set a value larger than 128
to increase the density.
Set a value smaller than 128
to decrease the density.
0 to 255 128
* Set the value in increments of approximately 20, while checking the printouts until the optimum value is
obtained.
3. Printer-specific Adjustments
3.3
To Next Page
Loading...
