e-STUDIO2500c/3500c/3510c
PCL6 PS3 Mac
* This adjustment will have an effect only on Auto or Color mode printing.
(2) If the photo image contrast is insufficient after the adjustment in procedure (1), enter adjustment mode [05].
Decrease the values for codes [8110 to 8117] to perform fine adjustment and decrease the sharpness
intensity.
• Adjust the value for [05] code corresponding to the print option to be applied (PDL, Color mode, and
Image quality type).
* Printing on Macintosh is performed in PostScript. (See the "PS3" row in the table below.)
PDL Color mode
Image
quality type
[05] code
Recommended
value
Acceptable
value range
Default
General 05-8110
Photograph 05-8111
Presentation 05-8112
PS3 Auto/Color
Line Art 05-8113
General 05-8114
Photograph 05-8115
Presentation 05-8116
PCL6 Auto/Color
Line Art 05-8117
Set a value
smaller than 128
0 to 255 128
* Set the value in increments of approximately 5, while checking the printouts until the optimum value is
obtained.
* Setting "108" provides an effect corresponding to "-1" for the sharpness option. It is recommended to set
approximately "118" corresponding to an intermediate value between "0" (default) and "-1" for the
sharpness option, and then perform fine adjustment, while checking the printouts.
<Note> • This adjustment changes the values set in the MFP. Therefore, it will affect every user who
uses the printer by connecting it to the MFP. After the adjustment, the values changed will be
applied to all printouts for the "Sharpness" option. Carefully perform the adjustment, being
aware that the image quality of all future printouts will be changed, when printing out originals
other than the one that is used for the adjustment.
• The code in the Standard Auto/Color mode is commonly used in the Twin-color mode. After
the adjustment, the values changed will be also applied to the image quality in the Twin-color
mode. When adjusting the image quality in the Standard mode, carefully perform the
adjustment, being aware that the image quality of all future printouts will be changed, when
performing printing in the Twin-color mode.
3. Printer-specific Adjustments
3.13
To Next Page
Loading...
