e-STUDIO2500c/3500c/3510c
PCL6 PS3 Mac
* This adjustment will have an effect only on Auto or Color mode printing.
(3) If smudges (toner scattering) are not eliminated after the adjustment in procedure (1), enter adjustment mode
[05]. Decrease the values for codes [8076 to 8078], [8080 to 8088] or [1092 to 1096] to reduce the amount
of toner used.
• Adjust the value for [05] code corresponding to the print option to be applied (Paper type, Image quality
type, Halftone, and PDL).
* Printing on Macintosh is performed in PostScript. (See the "PS3" row in the table below.)
Paper
type
Image quality
type
Halftone [05] code
Subcode
(PDL)
Recommended
value
Acceptable
value range
Default
Auto/Smooth
05-8076
General/Photograph/
Presentation
Detail 05-8085
Smooth 05-8076
Special 1
Line Art
Auto/Detail 05-8085
113
Auto/Smooth
05-8077
General/Photograph/
Presentation
Detail 05-8086
Smooth 05-8077
Special 2
Line Art
Auto/Detail 05-8086
113
Auto/Smooth
05-8078
General/Photograph/
Presentation
Detail 05-8087
Smooth 05-8078
Recycled
paper
Line Art
Auto/Detail 05-8087
128
Auto/Smooth
05-8080
General/Photograph/
Presentation
Detail 05-1092
Smooth 05-8080
Plain
paper
Line Art
Auto/Detail 05-1092
128
Auto/Smooth
05-8081
General/Photograph/
Presentation
Detail 05-1093
Smooth 05-8081
Thick 1
Line Art
Auto/Detail 05-1093
113
Auto/Smooth
05-8082
General/Photograph/
Presentation
Detail 05-1094
Smooth 05-8082
Thick 2
Line Art
Auto/Detail 05-1094
113
Auto/Smooth
05-8083
General/Photograph/
Presentation
Detail 05-1095
Smooth 05-8083
Thick 3
Line Art
Auto/Detail 05-1095
113
Auto/Smooth
05-8084
General/Photograph/
Presentation
Detail 05-1096
Smooth 05-8084
OHP
Line Art
Auto/Detail 05-1096
PCL6: 0
PS3: 1
Set a value
smaller than
the default.
0 to 255
128
* Set the value in increments of approximately 30, while checking the printouts until the optimum value is
obtained.
3. Printer-specific Adjustments
3.13
To Next Page
Loading...
