e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C © 2008 TOSHIBA TEC CORPORATION All rights reserved
2-70
(2) Enter the adjustment mode [05]. Change the values for codes [7025], [7064] to [7065] or [7675] to adjust
the reproducibility of the background when using the RADF.
Color mode [05] code Recommended value
Acceptabl
e value
range
Default
Black 05-7025
ACS / Black 05-7675
Full Color 05-7764
Monocolor 05-7765
Twin Color 05-7766
Set a value smaller than 128
to increase the density level
of the background.
Set a value larger than 128 to
decrease the density level of
the background.
0 to 255 128
* Set the value in increments of approximately 20, while checking the copy image until the optimum value is
obtained.
Precautions after the completion of the adjustment
Correctly adjusting the installation heights of the MFP and the RADF is a prerequisite to perform this adjustment.
Therefore, perform all the necessary adjustments. Only if further adjustment is still desired for the reproducibility of
background, should this adjustment be performed.
2. Copier-specific Adjustments
To Next Page
Loading...
