e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C © 2008 TOSHIBA TEC CORPORATION All rights reserved
3-62
PCL6 PS3 Mac
* This adjustment will have an effect only on Auto or Color mode printing.
(3) Enter adjustment mode [05]. Increase the values for codes [8042 to 8065] to increase the Low/Middle
density of the color.
• Adjust the value for [05] code corresponding to the print option to be applied (PDL and Halftone).
Ex.: • When printing on Windows is performed with the following options selected: PCL6, Image Quality
Type = General, Halftone = Auto
> Text area, graphic area and image area
Change the values for Y: 05-8058, M: 05-8059, C: 05-8060 and K: 05-8061.
• When printing on Macintosh is performed with the following option selected: Image Type =
Photograph, Halftone = Smooth
> Change the values for Y: 05-8050, M: 05-8051, C: 05-8052 and K: 05-8053.
* Printing on Macintosh is performed in PostScript. (See the "PS3" row in the table below.)
Color to
adjust
PDL Halftone [05] code
Subcode
Recommended value
Acceptable
value range
Default
Smooth
05-8058 0/1
PCL5c
Detail 05-8062 0/1
Smooth 05-8050 0/1
PS3
Detail
05-8054 0/1
Smooth 05-8042 0/1
Y
(Yellow)
XPS
Detail 05-8046 0/1
Smooth
05-8059 0/1
PCL5c
Detail
05-8063 0/1
Smooth
05-8051 0/1
PS3
Detail
05-8055 0/1
Smooth 05-8043 0/1
M
(Magenta)
XPS
Detail 05-8047 0/1
Smooth
05-8060 0/1
PCL5c
Detail
05-8064 0/1
Smooth
05-8052 0/1
PS3
Detail
05-8056 0/1
Smooth 05-8044 0/1
C
(Cyan)
XPS
Detail 05-8048 0/1
Smooth
05-8061 0/1
PCL5c
Detail
05-8065 0/1
Smooth
05-8053 0/1
PS3
Detail
05-8057 0/1
Smooth 05-8045 0/1
K
(Black)
XPS
Detail 05-8049 0/1
Set a value larger than 128. 0 to 255 128
* Set the value in increments of approximately 20, while checking the printouts until the optimum value is
obtained.
3. Printer-specific Adjustments
To Next Page
Loading...
