3 BASIC COPY MODES
74 Enlargement and Reduction Copying
Enlargement and Reduction Copying
You can change the reproduction ratio of copied images in the following procedures:
Automatic Magnification Selection (AMS):
You need to specify the copy paper size in advance. Then this equipment will detect the original size and
automatically select the optimal reproduction ratio for the copy paper size. Automatic size detection for
originals on the original glass is available only for e-STUDIO2550C Series / e-STUDIO5055C Series.
Specifying both original size and copy paper size separately:
You need to specify both the original size and the copy paper size separately in advance. According to the
sizes you specified, the optimal reproduction ratio is selected automatically. This feature is used when
Automatic Magnification Selection is not available, such as when copying OHP film originals.
Specifying reproduction ratio manually:
You can select the desired reproduction ratio by pressing [ZOOM] or one-touch zoom buttons on the touch
panel.
Copying photo originals in the optimal reproduction ratio for copy paper size (PHOTO ZOOM)
You can copy photo originals in the reproduction ratio best suited to the copy paper size.
The available range of reproduction ratio differs depending on whether the original is placed on the original
glass or on the RADF (Reversing Automatic Document Feeder).
Original glass: 25 to 400%
RADF: 25 to 200%
Automatic Magnification Selection (AMS)
Specify the copy paper size in advance so that this equipment will detect the original size and automatically
select the optimal reproduction ratio to the copy paper size. Automatic size detection for originals on the
original glass is available only for e-STUDIO2550C Series / e-STUDIO5055C Series.
This function is available when the size of the originals is as follows:
North America: LD, LG, LT, LT-R, ST-R and COMP (COMP is available only when the RADF is used.)
Other than North America: A3, A4, A4-R, A5-R, B4, B5, B5-R, FOLIO (FOLIO is available only when the
RADF is used.)
This function does not work properly for the originals noted below. Select other methods when copying
them.
y Highly transparent originals (e.g. OHP film, tracing paper)
y Totally dark originals or ones with dark borders
y Non-standard size originals (e.g. newspapers, magazines)
1
Place paper in the drawer(s).
To Next Page
Loading...
Need help?
General
