3 BASIC COPY MODES
86 Selecting Finishing Mode
Name of each part of the Inner Tray
MJ-1108
1. Upper receiving tray
2. Tray holder
3. Lower receiving tray
4. Sub-tray
5. Saddle stitch tray
6. Stopper
7. Front cover
8. Hole Punch Unit MJ-6104
9. Stapling control section
Using the tray holder
Open the tray holder when the length of the paper in the exit direction is longer than that of the upper
receiving tray. The holder prevents output paper from falling. Return it to its original position after use.
For consistent paper exiting, make sure you return the tray holder to its original position when using
paper shorter than the upper receiving tray.
MJ-5004
1. Tray
2. Paper stopper
MJ-5006
1. Tray
9
2
4
1
3
8
7
5
6
2
1
1
To Next Page
Loading...
Need help?
General
