4.OTHER PRINTING METHODS
Printing From UNIX/Linux 149
OTHER PRINTING METHODS
Folding
This sets whether the Folding feature is enabled or not using the following options:
If the Saddle Stitch Finisher is not installed or it is not specified, the default value of “folding=off” is used.
Example: The command to enable the Folding feature is “lp -o folding=on <filename>”.
The “Folding” option is available only when the Saddle Stitch Finisher is installed.
Output Bin
The output bin can be specified using the following options.
If the Finisher is not installed in the equipment, the default output tray will be used (inner). If the Finisher is installed in
the equipment, the default output tray will be used (bin2).
Example: The command to specify output bin 1 is “lp -o bin1 <filename>”.
Hole Punching
This sets whether a print job is printed with hole punches. When the hole punch option is installed it can be activated
using the following option.
If this option is not specified, the default value of “nopunch” will be used.
This function is not available for all paper sizes and the users should refer to the Copying for a list of compatible paper
sizes. In particular, A5, A6 and statement paper sizes will not work with this function.
Example: The command to hole punch the long edge feed portrait page is “lp -o punch=1 <filename>”.
Option Value Alternate Value Description
folding=off OFF Folding is disabled.
folding=on ON Folding is enabled.
Option Value Alternate Value Description
inner Select the inner tray.
bin1 Select the upper output tray of the Finisher.
bin2 Select the lower output tray of the Finisher.
Option Value Alternate Value Description
punch=0 nopunch Hole punching is turned off.
punch=1 Hole punch on long edge without rotation.
punch=2 Hole punch on short edge without rotation.
punch=3 Hole punch on long edge with 180 degree rotation.
punch=4 Hole punch on short edge with 180 degree rotation.
To Next Page
Loading...
