2.Copier-specific Adjustments
© 2018 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
2-51
(1) Press [Basic] on the Copy mode Panel and select the original mode option, as follows:
• To copy in the Full color or the Auto Color mode: Select the Printed Image mode option.
• To copy in the Black mode: Select the Photo mode option.
* When copying a photo image in the Full color mode, select the Photo mode option from among
the original mode options.
• To have “Text” selected from among the original mode options by default, perform the following
setting.
Press [User Functions -User-] and select [Copy] in the [User] tab. Select [Text] in the “Original
Mode for Black” or “Original Mode for Color” option.
After changing the default original mode option, copy and check the copy image quality.
If further image quality adjustments are still necessary, perform the next procedure.
(2) Press [Image] tab on the Copy mode. Press [Sharpness].
Press [Soft] to soften the copy image.
After softening the copy image, copy and check the copy image quality.
If further image quality adjustment is necessary, go to the next step.
(3) Select [05 ADJUSTMENT MODE]. Change the values for codes [7056] to [7058], [7061], [7062],
[7249] and [7794] to [7800] to adjust the default value for the sharpness intensity.
• Decreasing the sharpness intensity will minimize the edges of the image.
• The smaller the setting value is, the weaker the sharpness intensity becomes. The larger the
setting value is, the stronger the sharpness intensity becomes.
Changing the values for these codes will change the sharpness intensity, when the [Sharpness]
indicator in the [Image] tab on the Copy mode is set to the center. Remember that 1 step of the
indicator will increase or decrease the sharpness intensity by “25”. If the sharpness intensity of the
center value is changed, each step of the indicator will be changed accordingly. (For instance, if
the center value is decreased by “25” (softer), the value of each step of the indicator will also be
decreased by “25” (softer).)
Color mode Original mode [05] code
Recommended
value
Acceptable
value range
Default
Black
Text / Photo 05-7056
Set a value smaller
than 128.
(28 to 127)
0 to 255 128
Text 05-7057
Photo 05-7058
User Custom 05-7249
Image Smoothing 05-7061
Drop Out Color 05-7062
Full color
Text / Photo 05-7796
Set a value smaller
than 128.
(28 to 127)
0 to 255 128
Text 05-7797
Printed Image 05-7798
Photo 05-7799
Map 05-7800
User Custom 05-7795
Red Seal Color 05-7794
To Next Page
Loading...
