Toshiba e-STUDIO2515AC - To Adjust the Tint of Specified Colors for Twin-Color or Single-Color Copying

2.Copier-specific Adjustments
© 2018 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
2-75
2.17.3 To Adjust the Tint of Specified Colors for Twin-Color or Single-Color
Copying
 Explanation
In twin-color or single-color copying, the tint of the color specified from the control panel can be changed
by adjusting the toner amount of the color (Y, M, C or K).
 Procedures
The service technician must perform all adjustments.
(1) Select [05 ADJUSTMENT MODE]. Change the values of codes [7644] to [7653] to adjust the value
of Y, M, C or K for the tint of the specified color.
• Select the subcode (0 to 3) depending on which toner color (Y, M, C and K) you want to change.
• When the subcode for the specified color (Y, M, C or K) is larger, the toner amount for the adjusted
color increases, when the former is smaller, the latter decreases.
• If the value is too large, the density becomes too dark and the reproducibility of gradations in the
high density area may become blurred and degraded. Therefore, carefully perform the
adjustment, while checking the copy or print image.
• When all the subcodes are set to “0”, the specified color becomes white.
• Adjustments for yellow green, pink, orange and purple are enabled in mono color copying only.
Specified color
from the control
panel
Color of toner
amount to be
adjusted
[05] code Subcode
Acceptable
value range
Default
Magenta
Y
05-7644
0
0 to 255 128
M1
C2
K3
Yellow
Y
05-7645
0
0 to 255 128
M1
C2
K3
Yellow green
Y
05-7646
0
0 to 255 128
M1
C2
K3
Cyan
Y
05-76405-7
0
0 to 255 128
M1
C2
K3
Pink
Y
05-7648
0
0 to 255 128
M1
C2
K3