Toshiba e-STUDIO2515AC - To Print a Full-Color Original in Two Colors

3.Printer-specific Adjustments
© 2018 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
3-91
3.12 To Print a Full-Color Original in Two Colors
 Explanation
Select the twin color print mode option, in order to change colored text and lines on full-color original and
print out the original.
• The gradation reproduction for twin-color print can be switched by means of the following self-
diagnostic code.
• The Twin Color mode is not available when 1200 dpi is selected for the PS printer driver.
 Procedures
The procedure to use varies depending on whether “To Adjust Colors”, “To Adjust the Sharpness” or “To
Print a Full-Color Original in Two Colors”. Refer to the procedure corresponding to the particular user’s
request.
Before adjustment After Adjustment
The original is printed in the Full color mode.
The areas other than black is printed in the
same color (Red).
Enter [05 ADJUSTMENT MODE] and change the setting value for the code [8002].
[05] Code Setting value Contents Default
8002
0
Gradation reproduction priority (The gradation ability of
an original such as a photo becomes more emphasized.)
0
1
Text reproduction priority (Text or lines can be printed
more clearly.)