Toshiba e-STUDIO2515AC - To Adjust the Image Quality Scanned from the DF

2.Copier-specific Adjustments
© 2018 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
2-77
2.18 To Adjust the Image Quality Scanned from the DF
 Explanation
The reproducibility of the background may vary, depending on the type of original, or whether the
scanning is of an original placed on the original glass or one fed from the DF. Adjust the reproducibility of
background, while scanning an original fed from the DF, in order to minimize the gap in the reproducibility
of the background, using either method of how to scan an original.
• Correctly adjusting the installation heights of the MFP and the DF is a prerequisite to perform this
adjustment.
Therefore, perform all the necessary adjustments. Only if further adjustment is still desired for the
reproducibility of background, should this adjustment be performed.
Before adjustment After adjustment
The reproducibility of background may
vary, depending on how to scan an
original.
The gap in the reproducibility of
background is reduced.
To scan an original placed on the original glass
To scan an original placed on the original glass
To scan an original fed from the DF
To scan an original fed from the DF