Toshiba e-STUDIO2515AC - When Adjusting the Image Quality of the Full Color Mode

2.Copier-specific Adjustments
© 2018 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
2-97
2.24.2 When adjusting the image quality of the Full color mode
Both the service technician and the user can use all steps of this adjustment.
<Notes>
• This adjustment is available when the Text/Photo mode is selected for the original mode for full color
copying.
• Normally, the use with the factory default setting (Disabled) is recommended since the adjustment
may decrease the reproducibility of fine characters.
(1) Press [Image] tab on the Copy mode and then press [ADF Noise Reduction].
Change the setting value of the noise reduction level.
After changing the setting value, perform printing and check its image quality.
 Caution after the adjustment
Nothing in particular
Setting value Description
None The noise reduction function is disabled.
Low The noise reduction level is low.
Middle The noise reduction level is middle.
High The noise reduction level is high.