Toshiba e-STUDIO2515AC - Page 107

2.Copier-specific Adjustments
© 2018 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
2-53
(5) Select [05 ADJUSTMENT MODE]. Change the setting values for codes [7840], [7841] and [7842] to
adjust the reproduction level for the Text/photo, User Custom and Red Seal Color original modes.
• Adjustment for the User Custom setting is enabled in the Text/photo mode base only.
• Set the value in increments of 1, while checking the copy image until the optimum value is
obtained.
Set the value to “5” and check the copy image quality.
If further image quality adjustment is necessary, set the value to “4”.
If further adjustment is necessary, decrease the value step by step.
• Remember that if a value larger than “5” is set, the edges of the image are enhanced (attaching
importance to the reproducibility of text). The table below shows you the correlation between the
value and image quality.
• For the User Custom mode, refer to "2.19 To Program Frequently Used Copy Settings (To use
Custom Mode)".
 Caution after the adjustment
When an original containing text is copied, the adjustment may possibly cause the text to become
blurred on the copy. Therefore, carefully perform the adjustment, while checking the copy image.
 Remarks
Enter a value within the recommended value range mentioned in the procedures. Otherwise, it may
cause a loss in MFP performance, including degradation in the image quality.
Color mode Original mode [05] code Recommended value
Acceptable
value range
Default
Full color
Text/Photo 05-7840
Set a value smaller than
5.
0 to 9 0User Custom 05-7841
Red Seal Color 05-7842
Value Advantage of image quality Reproducibility of edges
0 Default Intermediate
1
Intended to improve the reproducibility of photos
more than the one obtained when “2” is set.
Soft
2
Intended to improve the reproducibility of photos
more than the one obtained when “3” is set.

3
Intended to improve the reproducibility of photos
more than the one obtained when “4” is set.

4
Intended to improve the reproducibility of photos
more than the one obtained when “5” is set.

5
Equivalent to the one obtained when the default
value (“0”) is set.
Intermediate
6
Intended to improve the reproducibility of text more
than the one obtained when “5” is set.

7
Intended to improve the reproducibility of text more
than the one obtained when “6” is set.

8
Intended to improve the reproducibility of text more
than the one obtained when “7” is set.

9
Intended to improve the reproducibility of text more
than the one obtained when “8” is set.
Sharp