2.Copier-specific Adjustments
© 2018 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
2-66
(4) Select [05 ADJUSTMENT MODE] and arrange the color balance by changing the setting values for
the codes from [7960] to [7987] to adjust the density for each color.
• Set the value in increments of approximately 10, while checking the copy image until the optimum
value is obtained.
The value for the code corresponding to the original mode (Text/Photo, Text, or Printed Image) will
affect the copy image quality in the Full color mode and the Auto Color mode.
• The subcode varies according to the area where the density is adjusted. Refer to the table below
and set the subcode for the area to be adjusted.
Caution after the adjustment
Nothing in particular.
Original
mode
Color to
adjust
[05] code Subcode Recommended value
Acceptable
value range
Default
Tex t/ Ph ot o
Y (Yellow) 05-7960 0/1/2
Set a value larger than
128 to increase the
density.
Set a value smaller than
128 to decrease the
density.
0 to 255 128
M (Magenta) 05-7965 0/1/2
C (Cyan) 05-7970 0/1/2
K (Black) 05-7975 0/1/2
Tex t
Y (Yellow) 05-7961 0/1/2
M (Magenta) 05-7966 0/1/2
C (Cyan) 05-7971 0/1/2
K (Black) 05-7976 0/1/2
Printed Image
Y (Yellow) 05-7962 0/1/2
M (Magenta) 05-7967 0/1/2
C (Cyan) 05-7972 0/1/2
K (Black) 05-7977 0/1/2
Photo
Y (Yellow) 05-7963 0/1/2
M (Magenta) 05-7968 0/1/2
C (Cyan) 05-7973 0/1/2
K (Black) 05-7978 0/1/2
Map
Y (Yellow) 05-7964 0/1/2
M (Magenta) 05-7969 0/1/2
C (Cyan) 05-7974 0/1/2
K (Black) 05-7979 0/1/2
User Custom
Y (Yellow) 05-7980 0/1/2
M (Magenta) 05-7981 0/1/2
C (Cyan) 05-7982 0/1/2
K (Black) 05-7983 0/1/2
Red Seal
Color
Y (Yellow) 05-7984 0/1/2
M (Magenta) 05-7985 0/1/2
C (Cyan) 05-7986 0/1/2
K (Black) 05-7987 0/1/2
Subcode Area where the density is adjusted
0 Low density area
1 Middle density area
2 High density area
To Next Page
Loading...
