5.Scanning-specific Adjustments
e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC © 2018 TOSHIBA TEC CORPORATION All rights reserved
5-26
When the noise reduction level for each [Low], [Middle] or [High] is changed, the service technician
must perform the following step.
(2) Enter [05 ADJUSTMENT MODE] and change the setting values for the codes from [7400] to [7404]
and from [8412] to [8415] to adjust the noise reduction level.
• Setting “200” provides the weakest noise reduction level, while setting “1” provides the strongest
one.
Moreover, when “0” is set for the setting value, this function becomes disabled.
• The noise reduction level for each [Low], [Middle] or [High] of [ADF Scan Noise Reduction] set
from the control panel is changed. Setting the recommended value provides the most effective
result.
After changing the setting value, perform scanning and check its image quality.
Caution after the adjustment
Perform the adjustment while checking the scanned images since the adjustment may decrease the
reproducibility of fine characters and lines.
Color mode Original mode [05] Code
Recommended
value
Acceptable
value range
Default
Black
Text/Photo 05-7401
90 to 120 0 to 200 100
Text 05-7402
Photo 05-7403
User Custom 05-7400
Full color
Text/Photo 05-8413
Text 05-8414
Photo 05-8415
User Custom 05-8412
Gray scale --- 05-7404
To Next Page
Loading...
